Cast Aluminum 3 Piece Bistro Dining Set
----Chair Installation Guide
Parts list
Backrest x1
Chair Seat x1
Leg(with pre-attached leveller) x4
④Washer (8mm) x11
⑤Spring Washer (8mm) x11
⑥Nut (8mm) x11
⑨Spanner x1
Assembly Preparation
Before Beginning Assembly:
Assembly Step
Backrest(D)
Chair seat(E)
Leg(with pre-attached
leveller)(F)
FRONT FACING
This Chair has multiple parts and may require up to 30 minutes to assemble. To
give you an overview of the Chair parts, the above picture is to help you put the
various parts into perspective. Please read through the instructions below to
familiarise yourself with the parts and steps before assembly.
Step 1
Unpack and place all parts on a clean, non-marring surface.
Step 2
2.1) Insert Bolts on Backrest(D) into the Chair Seat(E) as pictured above.
2.2) Attach Backrest(D) to Chair Seat(E) using Washers(④), Spring Washers(⑤),
and Nuts(⑥) with Spanner(⑨).
Do not fully tighten the Nuts.
Step 3
Insert the Legs(F) onto the Bolts on the Chair Seat(E).
Attach Legs(F) to Chair Seat(E) using Washers(④), Spring Washers(⑤) and
Nuts(⑥) with Spanner(⑨).
Tighten all Nuts at all Joints fully in a sequential manner.
Step 4
Adjust Pre-installed Levellers
height for balance
Stand the Chair up.
Adjust the Legs pre-installed Levellers, until the Chair is level with the ground.
Your Chair is now ready for use.
This Chair can only be used on a flat, level surface.